SA-4732-12 Shut off Solenoid

When the loader starts, the flame-out Solenoid valve works normally but it is difficult to start without landing, what should I do?

The inspection items such as the car cannot start, the idle speed is unstable, the speed is suddenly high, the speed is suddenly low, and the fuel supply is abnormal as follows:

1. The voltage of the car battery is low; Specific detection method: test the battery voltage with the voltage file of the three-use meter, if it is below 10V, it is recommended to replace it. If it is around 11V, it is barely used; Be prepared for replacement. Can be used above 12V;

2. Check whether it is caused by carbon deposits; IF YOU WALK ABOUT 20,000KM, FOCUS ON CHECKING AND CLEANING THE THROTTLE;

3. Inspection, testing and replacement of spark plugs;

4. Confirm the oil quality of the gasoline added;

5. Detect ignition switch;

6. Test and test the starter, gasoline pump, sensor and other relevant components of the starting and fuel supply system;

7. After the other power on, do not start immediately, wait 30 seconds to 1 minute, and then ignite; See if it works;

Regardless of any of the above circumstances, pay attention to the time when you can't hit the car, be sure to wait 15-30 seconds before calling.To protect the battery but not to generate electricity, extend its service life.